Let's stay Connected
We manufacture a complete range of terminal boards to keep all aspects of your Model Rail Layout Connected.
Here is a list of what we do in the order you will need them
The Heart of any system is the Power Source, if you have enough of it you can do anything. When choosing your Power supplies make sure you over compensate as you will grow into it. You dont want to be upgrading every year as your layout expands.
PW104 12vDC at 5 Amps
PW120 12vDC at 1 Amp
PW122 12vDC at 2 Amps
PW121 Variable 3v to 12v
at 2.25 Amps
PW123 12vDC at 3 Amps
You next may want to consider a fused Distribution board or two. This will protect all circuits from each other just in case one develops a fault.
CN168 Fused Distribution 5 way.
The wires from the Power Source down to the switching units would best be either 32/0.2mm or 24/0.2mm
Now you could go through a switched distribution system. We have an 8 way in a console (left), a 8 way chassis mounting (not shown), or a 6 way chassis mounting unit (right).
Each Switched Channel could now feed into any of the following Distribution Boards.
14 way AC, DC or DCC Single Polarity Mini Terminal Board
This is where you put all those common Negative wires, or common Positive wires
18 way AC, DC or DCC Terminal Block, with common on one side and separate common on other side
14 way AC, DC or DCC Terminal Block, with + & - side by side
Wires in this area can be 16/0.2mm or 7/0.2mm
Connection to individual equipment such as points or signals, you should use the MR230 or MR235 as most equipment comes with 3 short wires
Reverse Polarity Switch with Indicator for Point Motors or Track Centre OFF for Track Isolation
You could populate one of our switch consoles or panels with all your Point, Signal, Isolation switch and much more.
